工作原理

粉体物料与粘合剂在圆筒（锥形）形容其中，由底部混合浆充分混合成湿润软件，然后由侧置的高速粉碎浆切割成均匀的湿颗粒。

Powder raw material and adhesive are mixed to moisture soft material through mixing oar at the bottom of the cylinder(cone) container. Then cut it to become uniform damp granule through high speed crushing oar installed at the side.

特点

本机采用卧式圆筒构造，结构合理。

充气密封驱动轴、清洗时可切换成水。

流态化造粒、成粒近似球形，流动性好。

较传统工艺减少25%粘合剂，干燥时间缩短。

每批次干混2分钟，造粒1-4分钟，工效比传统工艺提高4-5倍。

在同一封闭容器内完成，干湿-湿混-制粒，工艺缩减，符合GMP规范。

整个操作具有严格的安全保护措施。

The machine adapts horizontal cylinder structure. Its structure is reasonable.

Adapt driving shaft through filled air sealing. When clean, it can turn to water.

Granulating in liquefied-state.Its fluidity is good.

Compared with traditional process,25% of adhesive can be saved and the drying time an be shorted too.

The dry mixing time will be 2,minutes and the granulating time will be 1-4 minutes. Compared with traditional process, its working efficency will raise 4-5 times.

The procedures of dry mixing- granulating can be finished in the same sealed container. Its procedure is shorted. It  is in conformity with the requirement of GMP.

Whole operation has atrict safe protective measure.